JIS Z9015-1-1999 计数检查用抽样程序.第1部分:逐批检查用以可接受质量水平为指标的抽样方案

上一篇: PD R009-002-1999 测试程序的术语使用指南
下一篇: BS ISO/TR 10064-4-1999 圆柱齿轮.检验实施规程.与表面纹理和齿轮齿接触模型检验相关的推荐方法

Product Code:SAE AS94900
Title:Aerospace - Flight Control Systems - Design, Installation and Test of Piloted Military Aircraft, General Specification For
Issuing Committee:A-6a3 Flight Control Systems Committee
Scope:This specification establishes general performance, design, test, development and quality assurance requirements for the Flight Control Systems of military piloted aircraft. Flight Control Systems (FCS) include all components used to transmit flight control commands from the pilot or other sources to appropriate force and moment producers. Flight control commands normally result in control of aircraft altitude, airspeed, flight path, attitude, aerodynamic or geometric configuration, ride quality, and structural modes. Among components included are the pilot驴s controls, dedicated displays and logic switching, system inertial and air data sensors, signal computation, test devices, mechanical transmission devices, actuators, power sources, and signal transmission lines dedicated to flight control. Excluded are aerodynamic surfaces, engines and engine control systems, rotorcraft rotors, fire control devices, crew displays and electronics not dedicated to flight control. In the event of conflict between this specification and other referenced documents, this specification shall govern. The detail requirements for a particular system shall be specified in the FCS Specification, 4.6.2, the Aircraft Detail Specification, the contract, or purchase order for that system.Most of the technical concepts and approaches covered by the document represent industry "best practice". They are based on sound and proven engineering practices and have demonstrated successful production experience. Others require specific approval from the procuring activity before use. This requirement for approval is not intended to prohibit their use; but rather to ensure that the prime contractor has fully investigated their capability to perform reliably and to be sufficiently durable under the required conditions and that the prime contractor can present substantiating evidence for approval before the design is committed to.【英文标准名称】:Machinestools;acceptanceconditionsformachinetoolsoperatingbyremovingmetal;generalrules
【原文标准名称】:机床.金属切削加工机床验收条件.一般规则
【标准号】:DIN8601-1986
【标准状态】:作废
【国别】:德国
【发布日期】:1986-12
【实施或试行日期】:
【发布单位】:德国标准化学会(DIN)
【起草单位】:
【标准类型】:()
【标准水平】:()
【中文主题词】:规范(审批);验收条件;检验;验收;材料有屑加工;金属加工;验收检验;验收规范;机床
【英文主题词】:material-removalprocesses;inspection;acceptanceinspection;machinetools;metalworking;acceptancespecification;acceptanceconditions;acceptance(approval);specification(approval)
【摘要】:
【中国标准分类号】:J50
【国际标准分类号】:4200
【页数】:30P;A4
【正文语种】:德语